Application coil for Ramaloop

Product detailed description

Application coil for RaMaLoop replaces the functionally original (glowing) antenna, in a wide spectrum of frequencies. It can be used from units of Hz to hundreds of kHz (up to 1 MHz). In this mode, it is advantageous to use RaMaLoop with an external excitation generator ElZapp, Super Ravo Zapper, F-SCAN, because using it only with its own integrated generator is unnecessarily complicated for the user. The application coil for RaMaLoop extends the usability of the RaMaLoop device by not being magnetically attached to the RaMaLoop body like the original, and thanks to the metre-long supply cable, it is much easier to handle. The application coil for RaMaLoop has a slightly higher efficiency than the original illuminated original and makes it easier to use RaMaLoop even in modes where its use could not do without its own creative procedures. The application coil for RaMaLoop is, in a practical sense, only two-dimensional and therefore more mobile. The additional application coil for RaMaLoop can also be energised in Booster mode if necessary, when impulses with greater energy are used. When the booster mode is on, it is desirable to have the RaMaLoop permanently connected to the charger, otherwise the built-in RaMaLoop battery will run out very quickly. Consult your advisor about using the RaMaLoop application coil.

The signal strength decreases with the square of the distance. So the closer to the coil, the stronger the field, exponentially.

Generally speaking, halving the distance increases the field strength by 6 dB, which is 4x

Model

100 cm (1 m) 0 dB

50 cm 6 dB

25 cm 12 dB

12.5 cm 18 dB

6 cm approx. 24 dB

3 cm approx. 30 dB

Expressed differently; 30 dB is a thousandfold. A RaMaLoop 1 m away generates approximately 1000x less field than an antenna lying on the application site.

At 2 m - 6 dB, at 4 m -12 dB. The difference between 3 cm and four metres is 42 dB.